Enum ShapeClass

#[repr(u8)]
pub enum ShapeClass {
    Reph = 0,
    Pref = 1,
    Kinzi = 2,
    Base = 3,
    Mark = 4,
    Halant = 5,
    MedialRa = 6,
    VMPre = 7,
    VPre = 8,
    VBlw = 9,
    Anusvara = 10,
    Zwj = 11,
    Zwnj = 12,
    Control = 13,
    Vs = 14,
    Other = 15,
}

Shaping class of a character.

Variants

Reph = 0

Reph form.

Pref = 1

Pre-base form.

Kinzi = 2

Myanmar three character prefix.

Base = 3

Base character.

Mark = 4

Mark character.

Halant = 5

Halant modifier.

MedialRa = 6

Medial consonant Ra.

VMPre = 7

Pre-base vowel modifier.

VPre = 8

Pre-base dependent vowel.

VBlw = 9

Below base dependent vowel.

Anusvara = 10

Anusvara class.

Zwj = 11

Zero width joiner.

Zwnj = 12

Zero width non-joiner.

Control = 13

Control character.

Vs = 14

Variation selector.

Other = 15

Other character.

Trait Implementations

impl Clone for ShapeClass

fn clone(&self) -> ShapeClass

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for ShapeClass

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Default for ShapeClass

fn default() -> Self

Returns the “default value” for a type.

impl Ord for ShapeClass

fn cmp(&self, other: &ShapeClass) -> Ordering

This method returns an Ordering between self and other.

fn max(self, other: Self) -> Self

where Self: Sized,

Compares and returns the maximum of two values.

fn min(self, other: Self) -> Self

where Self: Sized,

Compares and returns the minimum of two values.

fn clamp(self, min: Self, max: Self) -> Self

where Self: Sized,

Restrict a value to a certain interval.

impl PartialEq for ShapeClass

fn eq(&self, other: &ShapeClass) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl PartialOrd for ShapeClass

fn partial_cmp(&self, other: &ShapeClass) -> Option<Ordering>

This method returns an ordering between self and other values if one exists.

fn lt(&self, other: &Rhs) -> bool

Tests less than (for self and other) and is used by the < operator.

fn le(&self, other: &Rhs) -> bool

Tests less than or equal to (for self and other) and is used by the <= operator.

fn gt(&self, other: &Rhs) -> bool

Tests greater than (for self and other) and is used by the > operator.

fn ge(&self, other: &Rhs) -> bool

Tests greater than or equal to (for self and other) and is used by the >= operator.

impl Copy for ShapeClass

impl Eq for ShapeClass

impl StructuralPartialEq for ShapeClass